充電

1. Press the two release buttons at the ends of the PACK and lift it off its mounting plate. The plate and the safety tag with the QR code stay on the collar, so your dog always carries his ID.
2. Hold the magnetic pogo-pin cable near the four contacts on the underside of the PACK. The magnet pulls the cable into place with the correct polarity.
3. Plug the cable into a USB power adapter with 5 V DC output and at least 1 A (not included). The cable comes with a USB-C or USB-A plug, depending on your market.
4. The red LED stays on while the PACK charges and goes off when it is full, after about 2 hours.

Note: Never force the pins against the magnet’s direction. If the cable pushes away, turn it around and let the magnet guide it. Charge only between 0 °C and 60 °C.

The PACK has a built-in 750 mAh lithium-ion battery, which you cannot replace yourself. Standby lasts up to 6 months; an active dog typically needs a charge about once a week, depending on the tracking mode.

Check the battery

While the PACK is on, press the ON/OFF button once, briefly. The LED shows the battery status:

• Green: good and healthy.
• Yellow: moderate.
• Red: low, please recharge.

You can also see the battery status in the Light Dashboard of the app. To get a warning when the battery is low, turn on the low battery alert under Settings → Notifications Control.

Without pressing the button, a yellow LED means the battery is low, and a red LED while not charging means it is almost empty: charge it now.

追蹤模式

請前往「設定」→「裝置控制」變更模式。若要進行此變更，PACK 必須處於線上狀態。

• 監測：每 10 分鐘記錄一次位置。電池續航力最長。
• 自動模式：會根據動作自動調整。最適合日常使用的選擇。
• 追蹤：每 10 秒記錄一次位置。
• 即時：每 3 秒更新一次位置。請僅在您正在積極搜尋時使用此功能。

延長電池使用時間

• 在散步及居家監測時，請使用「自動模式」。
• 在住家周圍設定「安全區域」：在該區域內，PACK 的通報頻率會降低。
• PACK 在靜止一段時間後會進入休眠狀態，一旦移動便會甦醒。
• Turn on online/offline alerts, so you know when the PACK connects or disconnects.